Precision Machined Instruments - Monitoring And Testing Information

Articles & Whitepapers

Calculating Axial Loads on an Enclosed Impeller

The axial and radial loads placed on the impeller have an important effect on the reliable operation of a pump. Since the impeller is rigidly connected to the rotor bearings if these loads become too large the excessive bearing heat and shortened life may be experienced. Typically the pump is designed so that these loads are minimized, but some amount of thrust is inevitable and can be magnified ...

EES Scrubbing And Wesp Technology For Marine Industry

Abstract: Marine industry in the past traditionally did not required any Air Pollution Control regulations for obvious reasons of locations of the ships in the open far from the residential areas ...

Biogas Moisture, Corrosion and Accuracy Issues Resolved With Rugged FCI Thermal ST100A Wet Gas Flow Meter

Featuring a rugged, highly accurate thermal dispersion flow sensor, the ST100A Flow Meter from Fluid Components International eliminates wet gas and entrained moisture issues affecting biogas measurement accuracy in wastewater treatment digester ...

Showcase

Multipoint Thermal Mass Flow Meters

The MT100 Series is an insertion type, multipoint thermal flow meter specifically designed for large diameter pipes, such as stacks, industrial chimneys, and flues, and large rectangular ducts, such as air feed intakes and HVAC. These large pipe/duct applications are difficult for ordinary flow meters because of distorted flow profiles and lack of straight-run that can lead to inaccurate and ...